|
Post Reply
Saizoku 2007-10-31 12:58
Alright so i've been using UltraMon 2.7.1 for a while now and everything works fine untill today. My second monitor is kind of glappy (the screen goes red if everythings not in a special position) and so i tried to fix this and went a little overboard trying to put the converter in place on the pc. So it goes inactive, windows says it's inactive, ultramon says it's inactive and when i try to activate it. Nothing happens, after reboot it says it's inactive again, Help please
Sai
|
Christian Studer 2007-11-01 10:52
I'm not sure what would cause this, but if you also can't enable the monitor via Display Properties, it's most likely a hardware issue.
Christian Studer - www.realtimesoft.com
|
Saizoku 2007-11-03 06:08
So, what should i do to fix this?
Sai
|
Christian Studer 2007-11-03 08:33
This could happen for several reasons, for example the monitor is not connected properly, or there is a problem with the DVI-to-VGA adapter or the cable.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
